Shopping cart


Your cart is empty

0,-

Application simple

08.05.2018
Application simple:

1. Clean the base with ScanGlide Wax Remover.
2. Wipe the base with a fiber cloth.
3. Apply today's Nanoglider or 2X and let dry.
4. Polish with clean fiber cloth.
5. If desired, brush with nylon brush.
6. Leave the base to harden for 5 - 10 minutes.


God tur! (Have a nice trip)

Read more...

Application racing

08.05.2018

Application racing:

 

1. Carefully clean the base with the ScanGlide Wax Remover and brush over with a fine steel brush while the sole is still wet.

2. Wipe over with fiber cloth until the sole is free of any residues of previous products and ScanGlide Wax Remover.

3. Apply the ScanGlide Nanoglider XCT to a thin layer and allow it to dry. If any product left in areas, wipe it of with clean fiber cloth.

4. Polish with clean fiber cloth.

5. Brush carefully with nylon brush / rotor brush. Repeat points 3 - 5 once.

6. Apply today's Nanoglider, MT, CT, XCT or XR to a thin layer and let it dry. If any product left in areas, wipe it of with clean fiber cloth.

7. Polish the base with clean fiber cloth.

8. Brush carefully with nylon brush / rotor brush.

9. Leave to harden for 5-10 minutes.

 

God tur! (Have a nice trip)

Read more...

Application Shield GX

07.05.2018

Apply Shield GX:

  1. 1. On nevly preppared or used skis.
  2. 2. Apply Shield GX by dotting with the sponge with approxemently 5-10 cm space between.
  3. 3. Use the sponge to apply a thin coating all over the area you want to cover.
  4. 4. Let dry. You now have protection against oxydation and drying out the base.

Remove Shield GX:

  1. 1. Moistend aScanGlide fiberklut some water.
  2. 2. wipe of Shield GX with the moist fiber cloth.
  3. 3. Brush the base with nylon. 

 

God tur! (Have a nice trip)

 

Read more...